DNF Controls Tally Manager - Manual (Page 13)

Page 13 of 16
Monitor Wall Inputs Table
Each UMD line in the Input Table has three (3) entries:
UMD Source Device identifies the router or switcher output that feeds the
UMD input.
UMD# identifies the UMD on the monitor wall
Left Tally
(Primary) Source Device identifies the switcher or other device output that
indicates that the UMD source is on-air, in-record, or in-use. When this
tally is “ON”, the UMD text is red.
Left Tally# identifies the controlled tally object on the monitor wall.
Right Tally
(Secondary) Source Device identifies the switcher or other device output that
indicates that the UMD source is in-record or in-use.
Right Tally# identifies the controlled tally object on the monitor wall.
1) Launch your web browser and enter the Device Controller’s IP address. The DC Home
Page is displayed.
2) Click on the “Protocol Assignment” link at the top of the page. The Protocol
Assignment Table is displayed.
3) On the Protocol Assignment Table, on the Monitor Wall Channel row, in the “Tally
Manager Config” column, click on the “Inputs” link. The Monitor Wall Inputs web
page is displayed.
4) From the drop down menu displayed at the top of the Monitor Wall Inputs web page,
select the range of Inputs to be configured.
5) Click the “Edit” link near the top of the Router Inputs web page.