DNF Controls ST304-Edit User Manual

Page 18

Function Key

Press

Description

NEXT CUE

[NEXT CUE]

Step to the next Cue Point Location.

ON-AIR INDICATOR

GPI #7 in GPI Connector

(Not a key press)

When GPI #7 is active low, the 3 left softkey LEDs will turn o
When GPI #7 goes inactive, the LEDs will turn off.

PANEL LOCKOUT

SETUP MENU SETTING

When PANEL LOCKOUT is enabled, only the VTR select
keys, PLAY key, and MENU keys are active.

PREROLL TO CUE

[PREROLL]

Search the VTR to the IN Point, less preroll value of the
currently displayed cue point.

NOTE: If the IN or OUT point is not set (--:--:--:--), GOTO wi
not function.

AUTO-EDIT [SHIFT]+[RECORD]

Press

[SHIFT]+[RECORD] to start the AUTO-EDIT function

(AUTO-EDIT mode only)

PREVIEW EDIT

[SHIFT]+[RECORD]

Press [SHIFT]+[RECORD] to preview the edit.

(EDITOR mode only)

RECORD

[REC]+[PLAY]

With EDITOR mode disabled-

Press & hold [REC] and then press [PLAY] to record or
perform edit.

REVERSE

PLAY

[REV]

For T-BAR ONLY – HOLD key to play video in reverse.
RELEASE key to play forward.

REWIND

[RWD]

Press and HOLD to rewind. Release key to stop. Set WIND
Speed in MENU.

SEARCH TO TIME

[SHIFT]+[GOTO]

Press [SHIFT] + [GOTO] then manually enter a search time.

Press [ENTER] or [GOTO] to search to the entered time.

OR,

Press [PREROLL] to preroll to the entered time.

OR,

Press [ESC] to exit without searching.

SHUTTLE

[SHUTTLE]

Select SHUTTLE mode and enable the Wheel.

SLOMO

[SLOMO]

Press SLOMO to slo-mo the VTR. Turn the Wheel or move th
T-Bar to change the play speed.

Press SLOMO to STILL frame OR press any transport key to

exit.

SLO-MO SPEED
PRESET

[SHIFT] + [SLOMO]

For WHEEL ONLY - to preset the slo-mo speed. Turn the
Wheel to select desired speed.

Press [ESC] OR any transport key to exit.

STOP

[STOP]

Press once to STILL frame VTR.

Press again to put VTR into STOP mode.

TIME MODE SELECT [TIME MODE]

Press to toggle between Time Code (TC), VITC (VT) or Tape
Timer (TM) display modes.