Time code generator preset, Auto-edit function, Perform auto-edit – DNF Controls ST304-Edit User Manual
Page 11
F. TIME CODE GENERATOR PRESET
1. Press [SHIFT]+[TIME MODE] to enter Time Code Preset.
2. Press [ENTER] to load Time Generator with 00:00:00:00.
3. OR
4. Manually enter the time desired using the numeric keypad, then press [ENTER] to load
that time.
5. OR
6. Press [ESC] to exit without presetting the time code generator.
G. AUTO-EDIT FUNCTION
NOTE: CAN BE USED IN ASSEMBLE OR INSERT EDIT MODE.
1. SET IN POINT ON THE SELECTED VTR. (OUT POINT optional)
Press [IN] key to mark the current time code.
OR,
Press [SHIFT]+[IN] to manually enter an IN point. Press [ENTER] to accept
time code entry or [ESC] to exit without saving.
The [IN] key LED turns on when an IN point is set.
Press [OUT] key to mark the current time code.
OR,
Press [SHIFT]+[OUT] to manually enter an OUT point. Press [ENTER] to
accept or [ESC] to exit without saving.
The [OUT] key led turns on when an OUT point is set.
2. PERFORM AUTO-EDIT
NOTE: Set GANG mode if desired.
Press [SHIFT]+[RECORD] to start the AUTO-EDIT process. The VTR will
preroll by the amount of time set in the SETUP MENU. Roll to the IN POINT,
go into RECORD, cut out at the OUT POINT, roll two seconds past the out
point and stop.
S
S
T
T
3
3
0
0
4
4
-
-
E
E
D
D
I
I
T
T
&
&
S
S
T
T
3
3
0
0
4
4
-
-
E
E
D
D
I
I
T
T
-
-
T
T
,
,
S
S
l
l
o
o
w
w
M
M
o
o
t
t
i
i
o
o
n
n
C
C
o
o
n
n
t
t
r
r
o
o
l
l
l
l
e
e
r
r
7