Delete in(out) point, Trim in/out point, Preview edit – DNF Controls ST304-Edit User Manual
Page 13: Perform edit
The [IN] key led turns on when an IN point is set.
Press [OUT] key to mark the current time code.
OR,
Press [SHIFT]+[OUT] to manually enter an OUT point. Press [ENTER] to
accept or [ESC] to exit without saving.
The [OUT] key led turns on when an OUT point is set.
5. DELETE IN(OUT) POINT
Press [DEL] + [IN] (or [OUT]) to delete the IN/OUT point. The IN (or OUT)
led will turn off.
6. TRIM IN/OUT POINT
When an IN or OUT point is marked (IN or OUT indicator is on), the user may
change the time code value in two ways:
Manually enter a new value.
Press [SHIFT]+[IN] to manually enter an IN point. Press [ENTER] to accept
time code entry or [ESC] to exit without saving.
Press [SHIFT]+[OUT] to manually enter an OUT point. Press [ENTER] to
accept or [ESC] to exit without saving.
OR,
Trim the existing value.
Press the [TRIM] key.
The display will prompt “Enter Time, Select Key”.
Manually enter the amount of trim using the numeric keypad.
The top row of the display will show the entered amount.
Press [IN+] to add the trim amount to the IN Point.
OR,
Press [IN-] to subtract the trim amount from the IN Point.
OR,
Press [OUT+] to add the trim amount to the OUT Point.
OR,
Press [OUT-] to subtract the trim amount from the OUT Point.
7. PREVIEW EDIT
Press [SHIFT]+[RECORD] to preview the edit.
8. PERFORM EDIT
Press & hold [RECORD] then press [PLAY] to perform edit.
S
S
T
T
3
3
0
0
4
4
-
-
E
E
D
D
I
I
T
T
&
&
S
S
T
T
3
3
0
0
4
4
-
-
E
E
D
D
I
I
T
T
-
-
T
T
,
,
S
S
l
l
o
o
w
w
M
M
o
o
t
t
i
i
o
o
n
n
C
C
o
o
n
n
t
t
r
r
o
o
l
l
l
l
e
e
r
r
9