Installation – DNF Controls ST304-SRP User Manual
Page 7
5
5
ST304-SRP & ST304-SRP-T, Slow Motion Controller
3. INSTALLATION
a.
Connect VTR1 connector on the back of the ST300 to the REMOTE connector of
playback channel 1 on DDR 1.
b.
Connect VTR2 connector on the back of the ST300 to the REMOTE connector of
playback channel 2 on DDR 2.
c.
Connect VTR3 connector on the back of the ST300 to the REMOTE connector of record
channel 1 on DDR 1.
d.
Connect VTR4 connector on the back of the ST300 to the REMOTE connector of record
channel 2 DDR 2.
e.
Connect the supplied POWER SUPPLY, APX#4108 into the POWER connector on the
rear of the ST300. Plug the Power Supply into an outlet, 90 VAC – 240 VAC.
f.
Select REMOTE mode on the VTR’s front panel.
g.
Check the SETUP MENU prior to using the Slow Motion Controller to confirm proper
Record mode, SLO-MO speed range, and other User settable modes.