DNF Controls DMAT-AB - Manual (Page 8)

3. SELECT OPERATIONAL MODE
The DMAT-AB supports multiple modes of operation with the Mira. The mode
of operation is selected in the Setup Menu.
- 3 IN / 1 OUT: Supports 3 live record channels and 1 softkey for accessing
pre-recorded clips. Only supports 1 playback channel.
- 1 IN / 1 OUT: Supports 1 live record channels and 3 softkeys for accessing
pre-recorded clips. Only supports 1 playback channel.
- 2 IN / 2 OUT: Supports 2 live record channels and 2 softkeys for accessing
pre-recorded clips. Supports 2 playback channels with the
ability to perform cut / mix / wipe transitions between
playback channels.
- 6 IN / 2 OUT: Supports up to 6 live record channels. Does not support
softkeys for pre-recorded clip access. Supports 2 playback
channels with the ability to perform cut / mix / wipe
transitions between playback channels.
4. START RECORDINGS
All recordings must be started from the GUI of the Mira. To begin a new
recording:
A. On the Mira, open the Mira Explorer application.
B. Within Mira Explorer, select the channel you wish to record on.
C. Click on the Record button.
D. Enter a Clip Name for the new recording.
E. Click on “OK.” The record button will now be flashing red.
F. Click on the record button to begin recording.
5. ‘CAM’ KEY ASSIGNMENT
Assign Mira record channels to CAM keys. Press the corresponding {CAM-X}
softkey (ranging from {CAM-1} to {CAM-6}) to instantly access the associated
live or recorded video on the playback channel.
Press [SHIFT] + {CAM-X}
The current assignments are shown in the upper left portion of the display.
A list of available multiple angle clips in Mira are displayed on the right side
of the display.
A. Using the wheel, scroll through and find the CLIP ID for the multi-angle clip
current in record on Mira.