Save clip – DNF Controls DMAT-AB User Manual
Page 10

8. SAVE CLIP
A. Press [IN] to mark an IN point and overwrite an existing IN point using
the current timecode. Or enter a timecode using the numeric keypad and
press [IN].
B. Press [OUT] to mark an OUT point and overwrite an existing OUT point. Or
enter a timecode using the numeric keypad and press [OUT].
C. Press [SAVE CLIP] to save the IN and OUT points in the next available
clip number.
NOTE- If a CAM-X is currently selected, one clip for each CAM will be
saved automatically. If CLIP-X is currently selected, only one clip for
CLIP-X will be saved.
NOTE- If no IN / OUT Points are assigned, they will be automatically
generated using the AUTO-MARK HEAD and AUTO-MARK TAIL settings in
the Setup Menu. The IN Point will be set to the current time minus the time
set in AUTO-MARK HEAD. The OUT Point will be set to the current time
minus the time set in AUTO-MARK TAIL. If only the IN or OUT Point is
missing, it will be automatically generated using the same settings.
For determining which cue points apply to which channels, use the table
below.
MODE
SOFTKEY
CUE POINT NUMBERS
{CAM-1}
1000 – 1399
{CLIP-1}
2000 – 2399
{CLIP-2}
3000 – 3399
1 IN / 1 OUT
{CLIP-3}
4000 - 4399
{CAM-1}
1000 – 1399
{CAM-2}
2000 – 2399
{CAM-3}
3000 – 3399
3 IN / 1 OUT
{CLIP-1}
4000 - 4399
{CAM-1}
1000 – 1399
{CAM-2}
2000 – 2399
{CLIP-1}
3000 – 3399
2 IN / 2 OUT
{CLIP-2}
4000 - 4399
{CAM-1}
1000 – 1399
{CAM-2}
2000 – 2399
{CAM-3}
3000 – 3399
{CAM-4}
4000 - 4399
{CAM-5}
5000 – 5399
6 IN / 2 OUT
{CAM-6}
6000 - 6399
OR
Manually enter a clip number (3 digit number) using the numeric keypad,
and then press [SAVE CLIP] to save the IN and OUT points into the
entered clip number