DNF Controls Analyst, RS422/RS232 Tester With (LOG 1) SR Data Logging Option - Manual (Page 9)

The Analyst RS422/RS232 Tester Page 5 of 27
Select a character position using the [<<<] and [>>>] keys.
Use the knob to change the character at the selected position.
d) Press the [Next] key to save the new ID and exit to the MENU screen
OR,
Press the [Exit] key to exit without saving the new ID.
The Analyst is ready for use.
D. Analyst Test Modes
MAIN Screen
The Analyst RS422/RS232 Tester
Data Logging Option
Press key to select test mode:
SEND RECV MON. Menu
Sw #1 Sw #2 Sw #3 Sw #4 Sw #5 Sw #6 Sw #7 Sw #8
NOTE - ADAPTER mode and VTR mode are not available with Data Logging Option
MAIN Screen
TEST MODES-
Description
SEND Sender Mode is used for testing cables and signal paths.
RECV Receiver Mode is used in conjunction with SENDER mode for
testing cables and signal paths.
MON Monitor Mode is used for testing serial communication problems
between two pieces of equipment. Data Logging is accessed
through Monitor Mode.
MENU Menu Mode is used for setting up and configuring the Analyst.