DNF Controls 4000CL-AX - Manual (Page 8)

8 8 400 Clip Fast Access System, Accom Axess Protocol
9. SETUP MENU
Press [MENU]. The MENU indicator will turn on.
Turn the Wheel to select item to change.
Press [MENU] OR use the Softkeys to change the desired mode for that option.
Turn the Wheel at anytime to select another item.
Press [ESC] at anytime to exit SETUP MENU. The MENU indicator will turn off.
MENU MODES:
(Turning Wheel clockwise)
WIND
Press Softkey to select:
MODE HOLD (fast wind is maintained only while key is pressed)
OR
LATCH (fast wind is initiated and maintained with momentary key press)
Select fast wind speed (3.9 to 23.7) by pressing Softkey below SPD.
SLOMO
ST300 display shows:
Press Softkey [TBAR] (or [WHEEL]) to toggle between them.
NOTE- The T-BAR has a speed range of 0Î+200 with a detent at
+100% play speed OR 0 Î 100%, with a detent at +100.
For Wheel only:
Press Softkey [SPEED] to select SLOMO speed ranges:
Press Softkey to select: 0 ->+200 OR -100 -> +200.
Press Softkey [BACK] to return to SLOMO MENU.
Press [ESC] to exit SETUP MENU.
OR turn the wheel to select another item.
For Wheel only:
Press Softkey [PRSET] to select the SLOMO Preset Speed Mode
Press Softkey [UPDATE]. When exiting SLOMO mode, the last used
speed is saved in the Preset Speed register.
Press Softkey [STATIC]. The Preset Speed register is NOT updated
when exiting SLOMO mode. It is only changed by [SHIFT] + [SLOMO]
(PRESET SLOMO).
SLOMO with: WHEEL
TBAR
Speed Prset