DNF Controls 4000CL-AX - Manual (Page 10)

1 1 0 0 400 Clip Fast Access System, Accom Axess Protocol
10. FUNCTION TABLE
Function Key Press Description
GOTO
ENTERED
TIME [SHIFT] + [RECUE] Search the VTR to the manually entered time
Use the ST300 numeric keypad. Press [ENTER] or
[RECUE].
GANG [SHIFT] + [VTR #1]
OR
[SHIFT] + [VTR #2]
OR
[SHIFT] + [VTR #3]
OR
[SHIFT] + [VTR #4]
Individually press the VTR keys to be included in the
gang. The LED above the key will turn on. Press the
VTR key again to remove from gang, the LED above the
key will turn off. Press [ESC] to exit.
The VTR LEDs that are on show the gang.
The flashing LED shows which VTR is currently selected.
FFWD
[FFWD] Press and HOLD to shuttle. Release key to stop. Set
WIND Speed in MENU.
JOG [JOG] Select JOG mode and enable Wheel.
LAST CUE [LAST CUE] Step to the previous Cue Point Location.
NEXT CUE [NEXT CUE] Step to the next Cue Point Location.
REWIND
[RWD] Press and HOLD to shuttle. Release key to stop. Set
WIND Speed in MENU.
SHUTTLE [SHUTTLE] Select SHUTTLE mode and enable Wheel.
SLOMO
[SLOMO] Press [SLOMO] to slo-mo the VTR. Turn the wheel
(or move the T-Bar if available) to change the play speed.
Press [SLOMO] to STILL frame
OR press any transport key to exit SLOMO.
SLO-MO
SPEED
PRESET [SHIFT] + [SLOMO] For WHEEL ONLY: Press [SHIFT] + [SLOMO] to
preset the slo-mo speed. Turn wheel to select desired
speed. Press [ESC] or any transport key to exit.
STOP [STOP] Press once to STILL frame VTR.
Press again to put VTR into STOP mode.
TIME
MODE
SELECT [TIME MODE] Press to toggle between Timecode (TC), VITC (VT) or
Tape Timer (TM) display modes
LOOP
PLAY
[SHIFT] + [PLAY] Press to Loop Play the VTR