DNF Controls 4000CL-AX - Manual (Page 3)

3 3 400 Clip Fast Access System, Accom Axess Protocol
1. REVISION HISTORY
100803
Rev. 2.4 Company header information revised.
112103
Rev. 2.5 Updated Receive Cue List & Transmit Cue List
Function description.
Added DNF Controls Limited Warranty.
2. SYSTEM DESCRIPTION
The 400 Clip Fast Access System consists of the ST300-SSM VTR Controller and
Shotlist Software.
SHOTLIST provides fast access to existing video clips stored on Axess.
The SHOTLIST contains up to 400 CLIP IDs, stored in non-volatile memory in the
ST300.
Remotely view the CLIP IDs that exist in the Axess under control.
Any clip in the SHOTLIST can be quickly loaded by simply entering the 3 digit number
associated with its location, then pressing [LOAD]. Press [PLAY] to play the clip. Press
[RECUE] to recue to the beginning of the clip.
DEFINITIONS:
„ Throughout this document, the Accom Axess will be referred to as the
“Video Server”.
„ The ST300-S/SM is referred to as “ST300”.
„ Words surrounded by brackets, for example, [ENTER], are keys on the ST300.
[XXX] + [XXX] means hold the two keys down simultaneously.
3. SYSTEM INSTALLATION
1. Plug one end of a 9 conductor, RS422 serial cable into the 9 pin connector (VTR
1, VTR 2, VTR 3 or VTR 4) on the rear of the ST300. Plug the other end of the
cable into the 9 pin remote connector on the Video Server.
2. Connect the +5, +12, -12 VDC POWER SUPPLY into the POWER connector on
the rear of the ST300. Plug the Power Supply into an outlet, 90 VAC to 240 VAC.
3. Check SETUP MENU prior to using the ST300 to confirm proper Record mode
and other User settable modes.
4. Connect the Black Burst Generator through the supplied Sync adapter to the AUX
port on the rear of the ST300.
Installation is complete.