DNF Controls 4000CL-AX - Manual (Page 6)

6 6 400 Clip Fast Access System, Accom Axess Protocol
6. RECALL
1. Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE]
or by manually entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
2. Press [LOAD] on the ST300.
The ST300 will automatically load the Learned clips on the Learned VTRs, cue
the clips to the Learned time, then set the Learned GANG mode.
7. RECORDING ON THE AXESS FROM THE ST300
1. Remote protocol needs to be set for SONY 2.
2. Sync needs to be set for INPUT. The ST300, Axess and source need to have the
same sync.
3. Preroll on the ST300 needs to be set.
4. RECORD DELAY in the ST300 needs to be set to 4 frames. (Some
experimentation might be needed to find the correct number to re-record over the
first frame of a clip)
5. On the Axess: SETUP > UTILS SETUP > TIME CODE
Pre- & Post-Roll need to be set to ON and duration needs to match duration on the
ST300.
6. Press [SHIFT] + [REC] to set record duration.
7. Press [REC] to start recording. Press [STOP] to stop recording.
8. TRANSFERRING CUELIST
The TRANSMIT CUELIST function allows you to transmit your list of Cue Points to a
PC, using the provided utility software on the PC, or to another ST300. Transfer to a PC
requires OpSuite 3.0 software, which runs on a Windows-based computer. Contact DNF
Controls for more information.
To Transmit Cue Points to the ST300:
1. Connect the VTR4 connector on the back of the ST300 to the VTR4 connector of the
receiving ST300 using RS422 9-pin cable with TX and RX lines crossed.
(A “Turnaround” cable)
2. Press [MENU].
3. Scroll the wheel until “Transmit CUE List? YES=Enter, Exit=ESC” is displayed.
4. Press [ENTER] to start transmitting. The Display shows “Waiting to transmit” on the
first line.
5. When the Receiver is ready, transfer starts automatically. The Display now shows
”Transmitting cuelist”.