DNF Controls 4000CL-AX - Manual (Page 4)

4 4 400 Clip Fast Access System, Accom Axess Protocol
CONNECTION DIAGRAM
4. VIDEO SERVER SETUP
1.
Assign a serial port on the VIDEO SERVER:
a. Select 1001 > Setup > Remote Setup > VTR Setup
b. Select the channel.
c. Enable the RS422 port with the Softkey (example: CH.A – RS422-1)
d. Change the protocol to “Sony-2” with the Softkey
e. Press Exit > Exit > System Memory > Save
2. Connect the same sync signal that goes into the ST300 AUX port to the Sync
connector on the back of the Axess. Setup the Axess to use External Sync using
the Axess OnAir panel.
NOTES: The ST300 will default to Tape Time if a non-supported time mode is selected
on the ST300.
The ST300 in Clip List mode will display ‘Waiting for Axess’ message on the
first line of the display due to the delays in the Axess Protocol.
Setup is complete.