DNF Controls 2034CL-MAV-PBIO - Manual (Page 5)

5 5 2034CL-MAV-PBIO
Getting Started . . .
2. SYSTEM DESCRIPTION
The 300 Clip Instant Access System consists of the ST300-SSM VTR Controller and Shotlist
Software. The Video Server must support SONY DP Protocol.
The ST300 controls up to 3 video channels individually or ganged.
SHOTLIST provides instant access to existing video clips stored on SONY-MAV.
The SHOTLIST contains up to 300 CLIP IDs, stored in non-volatile memory in the ST300.
Any clip in the SHOTLIST can be quickly loaded by simply entering the associated 3-digit
number of its location, then pressing [LOAD]. Press [PLAY] to play the clip. Press [RECUE] to
recue to the beginning of the clip or to the “recalled” time if defined.
Upon receipt of the Learn command, the ST300 saves the CLIP IDs of the currently loaded clips,
the current IN time of each clip, the VTRs they are loaded on and the current GANG mode into
the appropriate Cue Point.
When the Recall command is received, the ST300 loads the learned Clips onto the learned VTRs,
cues the Clips to the learned time and restores the learned GANG mode.
DEFINITIONS
‰ Throughout this document, the MAV-555 will be referred to as “Video Server.”
‰ The ST300-S/SM as the ST300.
‰ The ST420 is referred to as the SHOTBOX.
‰ Words surrounded by brackets, for example, [ENTER], are keys on the ST300 or the
SHOTBOX. [XXX] + [XXX] means hold the two keys down simultaneously.
‰ “Softkeys” are the row of keys directly below the display that perform multiple functions in
MENU and other modes.