DNF Controls 2034CL-MAV-PBIO - Manual (Page 17)

1 1 7 7 2034CL-MAV-PBIO
Reference . . .
20. SETUP MENU
Press [MENU]. The MENU indicator will turn on.
Turn the Wheel to select item to change.
Press [MENU] OR use the Softkeys to change the desired mode for that option.
Turn the Wheel at anytime to select another item.
Press [ESC] at anytime to exit SETUP MENU. The MENU indicator will turn off.
MENU MODES (Turning Wheel Clockwise)
RECORD Press [MENU] to select the desired record mode: Crash (Full) or Lockout.
WIND MODE Press Softkey to select:
HOLD (Fast wind is maintained only while key is depressed.)
OR
LATCH (Fast wind is initiated and maintained with momentary key press.)
Select fast wind speed (3.9 to 23.7) by pressing Softkey below SPD.
SLOMO ST300 display shows
(Non T-Bar version):
ST300 display shows
(T-Bar version):
Press Softkey [TBAR] (or [WHEEL]) to toggle between them.
NOTE: The T-BAR has a fixed speed range of 0 Æ +200 with a detent at +100%
play speed.
For Wheel only:
Press Softkey [SPDRANGE] to select SLOMO speed ranges:
Press Softkey to select: 0 Æ +200 OR -100 Æ +200.
Press Softkey [BACK] to return to SLOMO MENU.
Press [ESC] to exit OR turn the Wheel to select another item.
For Wheel only:
Press Softkey [PRSET] to select the SLOMO Preset Speed Mode.
Press Softkey [UPDATE] when exiting SLOMO mode, the last used speed is saved
in the Preset Speed register.
Press Softkey [STATIC].
The Preset Speed register is NOT updated when exiting SLOMO mode.
It is only changed by [SHIFT] + [SLOMO] (PRESET SLOMO).
SLOMO with: WHEEL
SpdRange Preset
SLOMO with: TBAR
Wheel Speed Preset