DNF Controls 2034CL-MAV-PBIO - Manual (Page 12)

1 1 2 2 2034CL-MAV-PBIO
11. SETTING THE IN (OUT) POINT
a. MARKING THE IN (OUT) POINT
1)
Locate the clip to the desired IN (OUT) time.
2) Press
[IN] ([OUT]).
The IN (OUT) indicator turns on.
OR
Press [SHIFT] + [IN] ([OUT]) to manually enter a new IN (OUT) time.
3) Press
[ENTER] to save the entered time or press [ESC] to exit without saving.
NOTE: When manually entering IN and OUT points, they are always marked based on
tape time, not LTC, no matter what time mode is selected.
b. VIEW THE IN (OUT) POINT
1)
When the IN (OUT) indicator is on,
Press [IN] ([OUT]) to view the existing IN (OUT) Point.
2)
While viewing the IN (OUT) Point:
Press [MARK] to overwrite the saved time with the current time.
Press [RECUE] to search to the IN (OUT) point.
c. CLEARING AN IN (OUT) POINT
Press and hold [DEL] then press and release [IN] ([OUT]).
The IN (OUT) indicator turns off.
12. ENTER PREROLL VALUE
a. Press
[MENU] and turn the Wheel to “Enter PREROLL:”.
b.
Enter the desired preroll value using the ST300’s numeric keypad.
c. Press
[ENTER] to save the entered value.
OR
Press [ESC] to exit without saving.