DNF Controls 2034CL-MAV-PBIO - Manual (Page 19)

1 1 9 9 2034CL-MAV-PBIO
21. FUNCTION TABLE
Function
Key Press Description
GOTO ENTERED
TIME [SHIFT] + [RECUE] Search the VTR to the manually entered time.
Use the ST300 numeric keypad. Press [ENTER] or
RECUE].
FFWD
[FFWD] Press and HOLD to shuttle. Release key to stop. Set WIND
Speed in MENU.
JOG [JOG] Select JOG mode and enable Wheel.
LAST CUE [LAST CUE] Step to the previous Cue Point Location.
NEXT CUE [NEXT CUE] Step to the next Cue Point Location.
RECORD [REC] Places VTR into the Record mode selected by RECORD
MODE in the SETUP MENU. Press [RECORD] OR
[RECORD] + [PLAY].
REWIND
[RWD] Press and HOLD to shuttle. Release key to stop. Set WIND
Speed in MENU.
SHUTTLE [SHUTTLE] Select SHUTTLE mode and enable Wheel.
SLOMO
[SLOMO] Press [SLOMO] to slo-mo the VTR. Turn the Wheel (or
move the T-Bar, if available) to change the play speed. Press
[SLOMO] to STILL frame
OR press any transport key to exit SLOMO.
SLO-MO SPEED
PRESET [SHIFT] + [SLOMO] For WHEEL ONLY: Press [SHIFT] + [SLOMO] to preset
the slo-mo speed. Turn the Wheel to select desired speed.
Press [ESC] or any transport key to exit.
STOP [STOP] Press once to STILL frame VTR.
Press again to put VTR into STOP mode.
GANG VTRs
[SHIFT] + [VTR#1]
OR
[SHIFT] + [VTR#2]
OR
[SHIFT] + [VTR#3]
Press VTR keys to include in the gang. Press [ESC] to
escape gang setup mode.
Flashing LED indicates VTR being monitored for status.
TIME MODE
SELECT [TIME MODE] Press to toggle between Timecode (TC), VITC (VT) or Tape
Timer (TM) display modes.
LOOP CLIP [LOOP ENABLE] Press to loop a clip.