Delta 600, Temperatures, Set the daily program – Delta Dore PACK DELTA 600 User Manual

Page 4: User start-up, Presentation, Heating shutdown / standby mode

2700620 Rev.2_GB

Use . Use . Use . Use . Use . Use . Use . Use . Use . Use . Use . Use . Use . Use . Use . Use . Use . Use . Use . Use . Use . Use . Use . Use .

Temperatures

6.1 Setting the Frost Protection temperature

When starting up: Frost Protection = 7°C

Turn the knob to the

position.

➀

Press the

buttons.

Temperature selection (5 to 15°C)

6.2 Setting the Economy temperature

When starting up: Economy = 16°C.

Turn the knob to the

position.

➀

Press the

buttons.

Temperature selection (5 to 30°C)

IMPORTANT: In air conditioning mode, the economy
set-point temperature must be higher than the Comfort
set-point temperature.

6.3 Setting the Economy temperature

Default setting: Comfort = 19°C.

Turn the knob to the

position.

➀

Press the

buttons.

Temperature selection (5 to 30°C)

6.4 Viewing the measured temperature

Press

button.

The temperature of the room
is displayed.

Set the daily program

There are 4 preset programs.
You can select one of them
by turning the knob.

Continuous Frost
Protection (adjustable
from 5°C to 15°C)

Continuous Economy
mode (adjustable from

5°C to 30°C)

Permanent comfort
(adjustable from 5°C

to 30°C)

By default, Comfort
from 6:00 a.m. to
11:00 p.m. throughout
the week.

This program can be modified.

User start-up

5.1 Fitting batteries

Two LR03-type or AAA 1.5V alkaline batteries
(autonomy >1 year).
"No rechargeable batteries".
To install them, remove the unit from its base, insert
the batteries, being careful to put them in the correct
direction, then return the unit to its base.

Replacing batteries:
If the low battery LED

comes on, do not leave the

flat batteries in the unit (the guarantee does not cover
damage caused by leakage from batteries).

You have approximately 1 minute to insert the new
batteries before the time you have set is erased.
The programs remain saved no matter what.

Presentation

5.2 Time setting

Turn the knob to the

position.

Set the time and day by pressing

and

Each time you pass 24:00 you
change the day.

Press and release
Changes in 1-minute steps

Press and hold
Fast forward

1
2
3
4
5
6
7

Heating shutdown /

Standby mode

Switching to standby for operation outside heating
periods.
Turn the knob to the

position.

The unit displays 4 dashes.

Modifying and saving your program

Turn the knob to PROG

The temperature display goes off.
The program assigned to the 1st day appears.
The 1st time slot flashes on and off.

➀

Press

for 1 Comfort hour or

for 1 Economy hour

(goes to next time slot).
Repeat the operation for each time slot.

➃

You must press

to confirm and go to the next day

Repeat operations

➀

and

➃

for

each day.

→

When you have finished programming, turn the knob to

AUTO.

For the

and AUTO modes, the displayed

temperature is the set-point temperature for the current
time slot.

E.g.: Day 3, it is 8:15 p.m.

The relevant time slot flashes.
The comfort temperature
is requested and its value
is displayed.

Day 3, it is 4:20 a.m.

The Economy set-point

temperature is displayed.