Daktronics C44 - Manual (Page 38)

3-10 C-44 Race Timer
Operation
Continue to make entries until all the desired factors have been entered. If no entry
is needed, just use the tab key to move to the next factor. Note: Although three sets
of factors are available, it is not necessary to use them all. If only one set is needed,
just enter that set and leave the others alone.
When all factors have been entered, press the <ESC> key to return to the Setup
menu.
Tree Countdown Modes
There are many possible
combinations of sequences and rates
of countdown for the tree. The
following is a list of available
sequences and rates. They can be
used in any combination. The tree
delay is used to select a delay for
the use of LED trees. It can be set
from .00 to .05. If no delay is
needed it should be set to .00.
Pro Tree Sequences Rates Full Tree Sequences Rates
Instant Green .2 sec 2 amber .2 sec
Pro (1 amber) .3 sec 3 amber .3 sec
Pro (3 amber) .4 sec 5 amber .4 sec
.5 sec 3x amber .5 sec
Finish Line Distance
Option D is used to select the track length that the
timer will be configured for. The user may specify
a finish distance of:
1/4 mile
1/8 mile
Event and Sponsor
Information
From this menu, the track name, event
name, and two sponsor ad lines are
entered.
All information entered in this fashion
will be printed on each time slip. An
example of the time slip printout can be
seen in Figure 11.
Figure 9: Combinations
Figure 10: Finish Line Distance
Figure 11: Time Slip Information