Daktronics Sportsound 500HD - Manual (Page 20)

14 Maintenance & Troubleshooting
3. Attaching New Speaker Mesh
When ordered through Daktronics, the mesh has a line with a series of tick marks
printed on the front (Figure 18). These tick marks are used to indicate the location of
the tension clips and mandrels.
a. Place a mandrel, smooth side up, centered on the tick mark.
b. Fold the mesh around the mandrel. Ensure the groove in the mandrel is
towards the inside of the mesh (Figure 19).
c. Snap a tension clip over the mandrel and mesh (Figure 20). Do not try to
drive both ends of the clip down onto the mandrel and fabric at the same
time; snap one end down and then the other.
d. Continue to place a mandrel and tension clip on every tick mark.
Figure 18: Tick Marks on Mesh
Figure 19: Folding Mesh
Figure 20: Attach Tension Clip