Daktronics Sportsound Announcer's Interface - Manual

Sportsound Announcer's Interface Quick Start Guide
DD2222104 Rev 1
24 September 2014
201 Daktronics Drive PO Box 5128, Brookings, SD 57006-5128
Tel: 1-800-DAKTRONICS (1-800-325-8766) Fax: 605-697-4746
Web: www.daktronics.com/support
1. XLR input jack - connect gooseneck or headset microphone
2. HEADPHONE VOLUME – Turn this knob clockwise to increase and
counter-clockwise to decrease headphone volume.
3. MIC LIVE – This LED indicator lights up when the microphone is live.
4. CONTINUOUS – Press this button once to activate the microphone
and turn on the MIC LIVE indicator. Press this button again to
deactivate the microphone and turn off the MIC LIVE indicator.
5. MOMENTARY – Hold down this button to activate the microphone.
Release this button to deactivate the microphone. The MIC LIVE
indicator will remain on as long as the button is pressed.
6. HEADPHONES – ¼" jack for headphones
7. MIC 1 – XLR output jack to audio mixer
8. AUX 1 – XLR input jack from audio mixer
9. POWER INPUT – plug in provided 12 VAC wallpack transformer;
device will also accept a 24 VDC wallpack
10. MIC ONLY/MIXED AUDIO – Located on the bottom
of the console, this switch determines whether the
announcer can hear only their microphone or all audio
sources through the headphones.
Leave this set to MIC ONLY unless there is a source
plugged into the AUX 1 jack.
1
2
3
4
5
6
7
8 9
10