Daktronics Sportsound SSR-100 Quick Start Guide - Manual

Sportsound SSR-100 Quick Start Guide 1 of 3
DD2753515 Rev 1
23 January 2015
201 Daktronics Drive PO Box 5128, Brookings, SD 57006-5128
Tel: 1-800-DAKTRONICS (1-800-325-8766) Fax: 605-697-4746
Web: www.daktronics.com/support
This guide will assist with starting up and operating a Sportsound ® SSR-100
audio rack. For detailed operation, configuration, and troubleshooting,
refer to the Sportsound Rack SSR-100 Operation Manual (DD2746938) .
Startup
Before Beginning: Place the rack on a flat, sturdy surface. Remove the
front and rear cover pieces by releasing all latches; set the covers aside.
1. Connect one end of the XLR gooseneck to the wired microphone
and the other end into the jack on top of the announcer’s interface.
Optional headset microphone may be plugged here instead.
2. Connect the 15' (4.6 m) XLR cable from MIC 1 & AUX 1 on the
announcer’s interface to MIC 1 & AUX 1 OUT (A) on front of rack.
3. Connect one end of the 2' (0.6 m) or 5' (1.5 m) XLR cable to the
LTIBLOX interface and the other end to MIC 2. The 3.5 mm plug
may be connected to the headphone jack of a laptop or MP3 player.
4. Connect the 25' (7.6 m) XLR cable between the MAIN OUT (B)
jack on the front of the rack and the SYSTEM AUDIO jack on the
bottom of the fiber box. If there is no fiber box, as in an indoor
audio system, the cable will typically connect to a wall plate
junction box instead.
5. Locate the 3-prong power cord in the rear of the rack and plug into
a standard outlet. Ensure the announcer’s interface and fiber box (if
included) also have power.
6. Turn on the power strip.
7. Switch the SIGNAL to ON.
Power Down
Follow the above steps in reverse order to power down the system.
Place all accessories in a secure location to avoid damage/theft.
Ensure any antennas are angled outward at ~45◦. Alternately, coaxial
cable from the high gain antenna kit may be connected into WRX A
and WRX B. The antennas should be located within 50' (15.2 m) of
the rack, using desktop stands or mounted to the ceiling.
Announcer’s
Interface
1
2
Rear View
Front View
4
5
3 7
45◦
OR
Fiber Box
(outdoor) Wall Plate
(indoor)
Laptop
Interface
(optional)
Audio
Mixer
Wireless Mic System
6