Daktronics AF-3180-64-R,A - Manual (Page 34)

1. If using a quick connect cable, connect from the Client Radio to J33 on the
back of the display.
2. When connecting directly to the display, terminate the other end of the
cable to the 6-position terminal block (TB1) on the Controller, labeled
“RS232 IN”
Figure 32: Radio Display Controller
Figure 33: Client Radio Connections
Note: Cable shield should not be terminated at Venus ® 1500 Radio Client
Radio Client to Controller Board (A31)
Venus 1500
Radio Client
Field
Cabling
Controller Board
RS232 IN (TB1)
Pin 6 (TX-P) Red Pin 5 (RX-P)
Pin 5 (RX-P) Blue Pin 3 (TX-P)
Pin 4 (GND) Green Pin 4 (GND)
Pin 7 (10 VAC) Black Pin 1 (V+ UNREG)
Pin 8 (10 VAC) White Pin 4 (GND)
Shield Pin 4 (Shield)
Electrical Installation 3-14