Daktronics AF-3180-64-R,A - Manual (Page 13)

In addition, various Daktronics drawings may contain the following labeling formats:
• “TB_ _” shows a termination block for power or signal cable.
• “F_ _” denotes a fuse.
• “E_ _” signifies a grounding point.
• “J_ _” stands for a power or signal jack.
• “P_ _” represents a power or signal plug for the opposite jack.
Finally, drawings commonly have Daktronics part numbers. You can use those part
numbers when requesting replacement parts from Daktronics Customer Service.
Take note of the following part number formats:
• “0P-_ _ _ _-_ _ _ _” gives the form of an individual circuit board, such as a
line receiver.
• “ 0A-_ _ _ _-_ _ _ _” represents an assembly, such as a circuit board and the
plate or bracket to which it mounts. A collection of circuit boards working
as a single unit may also carry an assembly label.
• “W-_ _ _ _” indicates a wire or cable. Cables may also carry the assembly
numbering format in certain circumstances. This is especially true of ribbon
cables.
• “F-_ _ _ _” signifies a fuse.
Figure 7: Typical Label
Most circuit boards and components within
this sign carry a label that lists the part
number of the unit. If the Replacement Parts
List in Section 4.13 does not list a circuit
board or assembly, use the label to order a
replacement. Figure 6 on the right illustrates
a typical label. The part number is in bold.
Introduction
1-7