Daktronics AF-3180-64-R,A - Manual (Page 33)

Figure 31: Fiber Signal Connections
Signal Converter to Fiber Board (A3X)
Signal
Converter
Field Cabling Fiber Board
J2 (TX1) (Color varies) J5 (RX)
J3 (RX1) (Color varies) J4 (TX)
Venus
®
1500 Radio Client
Reference Drawings:
System Riser, QC Outdoor Radio, Gen 2 ............. Drawing A-185359
Schem, Sig Wiring, Internal, W/Q CPCB............... Drawing B-177662
A display that is controlled using a radio requires a Server radio connected to the
control computer, and a Client radio at the display. The radios must be within line-
of-sight of each other. The diagram below shows the connections through a signal
converter. The Client radio must be located within 25 feet of the display, therefore
25 feet of cable is supplied with the Client radio. One end of the cable is pre-
terminated to TB1 inside the radio enclosure, and a quick connect plug is terminated
at the other end of the cable. If necessary the cable can be cut and terminated directly
to the controller board in the display. Refer to Drawing B-177662 for the correct
cable terminations and to Drawing A-185359 for the system riser. Additional
drawings are in the Radio manual (ED13932).
Electrical Installation 3-13