Daktronics Galaxy AF-3400 34 mm Monochrome/RGB - Manual (Page 27)

4.3 Fiber Optic Communication
If the communication system is Fiber Optic, look for:
• a signal converter near the computer.
• fiber-optic cables connecting the signal converter to an enclosure at the display.
Figure 17: Fiber Serial Communication Layout
Connections
• Computer to signal converter − six-foot (2m) cable with 9-pin plug connecting to computer
port or USB adaptor and 25-pin plug connecting to the signal converter at J1, RS232 IN.
• Signal converter plugged into a 120 volt AC outlet.
• Signal converter to fiber optic board at display − two individual fiber-optic cables connect
to signal converter at either J4 and J5 or J3 and J2; other end runs to fiber optic board at
display.
• Fiber optic board to display − quick-connect cable from enclosure to the top jack on display
back.
DO NOT SHARPLY BEND fiber-optic cable at any point along the fiber cable.
Troubleshooting
Component
Check:
Cable
Connections:
•
The serial cable is connected from the computer to the signal converter.
•
Both fiber optic cables are connected at the signal converter and the fiber board.
•
The cable from the enclosure is connected to the top jack on display back.
Diagnostic
LEDs
•
The green LEDs on the signal converter and the fiber optic board in the enclosure
will be on when they have power.
•
The red transmit and amber receive LEDs on both components will flash when
sending and receiving signal from the display; otherwise they are off.
Display Power:
•
The display is either running a message or showing a single pixel flashing in the
bottom right corner of display when power is on.
Software:
•
The software and the display are set for the same network address.
•
Refer to the software manual for other possible conditions.
Signal Installation
19