2 list of reference drawings, List of reference drawings, Figure 4: back and side views of typical display – Daktronics Galaxy AF-3400 34 mm Monochrome/RGB User Manual
Page 12
Figure 4: Back and Side Views of Typical Display
Pre-installation Checklist
Verify the following before proceeding with installation:
•
The display is in good condition after shipping and uncrating.
• A straight and square mounting frame is provided for the display.
Height variation in any four-foot horizontal section may not exceed ¼-inch.
• Adequate support is provided for the display so that the structure will not yield at
any unsupported points after mounting.
• Clearance of 4" of unobstructed space above the top of the display is allowed to
remove the eyebolt.
Note: No clearance is required once the eyebolt is removed.
•
Clearance in front of the display is maintained to allow unobstructed air flow
through the vents and to allow access to internal components.
•
Clearance is maintained in the area of the fans if located on the display back.
2.2 List of Reference Drawings
Shop drawings provide the exact locations of the display mounting hardware, as well as the
location of power and signal termination. A Shop Drawing was provided when the display
order was placed. However, if a Shop Drawing is needed, use this list to find the correct
number and request one from the Daktronics Customer Service. Note that they are listed by
the pixel matrix size of the display.
Shop drawings, listed by pixel matrix size
Shop Dwg, AF-3400-8x48-34 ................................................................ Drawing B-216498
Shop Dwg, AF-3400-8x64-34 ................................................................ Drawing B-216500
Shop Dwg, AF-3400-8x80-34 ................................................................ Drawing B-216501
Shop Dwg, AF-3400-8x96-34 ................................................................ Drawing B-216503
Shop Dwg, AF-3400-8x112-34 .............................................................. Drawing B-216504
Shop Dwg, AF-3400-8x128-34 .............................................................. Drawing B-216506
Shop Dwg, AF-3400-8x144-34 .............................................................. Drawing B-216507
Shop Dwg, AF-3400-8x160-34 .............................................................. Drawing B-230801
Shop Dwg, AF-3400-8x176-34 .............................................................. Drawing B-230802
Shop Dwg, AF-3400-8x192-34 .............................................................. Drawing B-230803
4
Mechanical Installation