Daktronics Galaxy AF-3400 34 mm Monochrome/RGB - Manual (Page 15)

Mechanical Installation
2.3 Display Mounting
The installer is responsible for ensuring that the installation adequately meets local
codes and standards, including safe, adequate mounting hardware and procedures.
1.
Lift the display into position on the support structure following the guidelines in
Figure 5.
Do not attempt to permanently support the display by the eyebolts.
Figure 5: Correct/Incorrect Lifting Procedures
2.
Weld or use 1/2" Grade-5 bolts and hardware to secure the clip angles to the support
structure as shown in the Shop Drawing. Attach all clip angles to structure.
3.
Refer to Section 3 and the appropriate communication manual for information on
routing power and signal to the display.
4.
After installation is complete, carefully inspect the display for any holes that may
allow water to seep into the display and seal all openings with silicone.
If the eyebolts on the top of the display have been removed, plug the holes with bolts
and the rubber-sealing washer that was removed with the eyebolt, unless an overhead
structure protects the area.
2.4 Optional Temperature Sensor Mounting
If a temperature sensor will be used with this display, see Appendix B for mounting and
signal connections.
7