Daktronics Galaxy 46 mm Outdoor Series AF-3400 - Manual (Page 49)

Maintenance and Troubleshooting
4-15
Temperature always reads –196F/-
127C degrees F/0 degrees C.
• Check temperature sensor cable connections.
• Check for correct power on temperature
sensor.
• Check that the temperature is set to address
1.
• Replace the temperature sensor.
Display is stuck on bright or dim. • Check Manual/Auto dimming in Venus 1500
software.
• Check light detector cable/wiring.
• Check light detector for obstructions.
• Replace the light detector.
• Replace the controller.
4.11 Initial Operation Information
Every time the display is operated, the display will run through an initialization in
which it will display the following:
1. Product Name (Galaxy®)
2. Display Size (Row x Column)
3. Shading (64 Mono)
4. Bootloader Version (OS X.XX)
5. Firmware Number (ED-13305)
6. Firmware Revision (Rev X.XX)
7. Hardware Address (HW:XX)
8. Software Address (SW:XX)
9. IP Address: ((default) IP: 172.16.192.25)
10. Subnet Msk: ((default) Msk: 255.255.0.0)
11. COM1 Configuration (C1:V15) ((Modem C1:V15) If a Modem is present)
12. COM 2 Configuration (C2: RTD)
13. Socket 3001: (IP 3001: V15)
14. Socket 3002: (IP 3002: RTD)
15. Line Frequency (CLK: AUTO (60))
16. Display Name Description (Galaxy Row x Column)
After this sequence is complete, the display will go blank. A single pixel will flash
in the lower right hand corner of the display to show that the display has power, but
no messages are currently running.