beautypg.com

Daktronics Galaxy 46 mm Outdoor Series AF-3400 User Manual

Page 45

background image

Maintenance and Troubleshooting

4-11

Diagnostic LEDs are located on the controller. The table below tells what each LED
denotes:

CPU

LED Color

Function Operation

DS1

Red

CAN TxD

Flashes when controller is transmitting CAN information.

DS2

Red

CAN RxD

Flashes when controller is receiving CAN information.

DS3

Red

System Reset

Off when controller is functioning properly. Flashes at 1.5-

second rate if controller is not resetting the watchdog timer.

DS4

Red

Run

A steady flash indicates the controller is running properly.

Normal flash rate is about once per second.

DS5 Red

U15

Programmed

On when U15 contains a valid logic program.

DS7

Red

Link

On when Ethernet interface is in the link-up condition.

Flashes when the Ethernet chip detects transmits or

receives activity.

DS8

Red

Speed

On when the Ethernet interface is at 100Mbps. Off when

the Ethernet interface is at 10Mbps.

DS9

Red

Duplex

On when the Ethernet interface is at full duplex. Off when

the Ethernet interface is at half-duplex.

DS10

Red

Collision

Flashes when the Ethernet interface detects a collision in

half-duplex.

DS12

Red

+2.5V

On when +2.5V power supply is functioning.

DS13

Red

+3.3V

On when +3.3V power supply is functioning.

Product Board

LED Color

Function Operation

DS1

Green

+5V

On when +5V power supply is functioning.

DS2

Green

+3.3V

On when +3.3V power supply is functioning.

DS3

Yellow

COM1 TxD

Flashes when transmitting serial information.

DS4

Yellow

COM1 RxD

Flashes when receiving serial information.

DS5

Yellow

Light

Flashes when receiving signal from light sensor.

DS6

Yellow

Com 2 RX2

Normal state is ON. When connected to receive RTD

input, the LED will be OFF. The LED flashes when

receiving signal from RTD input device.

Temp Sensor

LED Color

Function Operation

DS1

Green

+5V

On when +5V power supply is functioning.

DS2

Red

Run

A steady flash indicates the controller is running correctly.

Normal flash rate is about once a second. Flashes faster

when the sensor is transmitting temperature or light

information.

This manual is related to the following products: