Section 5: start-up procedure, 1 start-up checklist, 2 start-up sequence – Daktronics Galaxy AF-3500 Series Double Face User Manual

Page 15: 3 post installation checklist, Section 5, Start-up procedure, Start-up checklist, Start-up sequence, Post installation checklist

Start-Up Procedure

Section 5: Start-Up Procedure

Before starting up the display, review this checklist to ensure that all parts are ready to operate correctly.

5.1 Start-Up Checklist

• Confirm that power is correctly connected to the display.

• Allow for sufficient power as listed in the display Shop Drawing and Power Specs.

• Assure a main disconnect switch is used to control power.

• Inspect all circuit breakers (internal and external) for sufficient marking and size.

• Confirm that adequate grounding is installed. Each display face must have a separate earth-ground

conductor with a resistance of 10 Ohms or less.

• Assure the external communication equipment (signal enclosure, client radio, etc.) is properly installed.

• Inspect signal connections at the control computer.

• Inspect signal connections at the display.

• Inspect signal connections between displays when necessary.

• Confirm that the control computer is correctly configured.

Follow the step-by-step directions in the Venus

1500 Help File’s Configuration section for correct setup.

• Inspect peripheral equipment (temperature sensor, etc.) for proper installation.

5.2 Start-Up Sequence

Each time the display is turned on, an initialization sequence
runs, showing the information in the right column below.

Note: The Xs refer to numbers that vary for each display,
such as the hardware address.

5.3 Post Installation Checklist

Verify the following after starting the display:

• Assure all ventilation fans are fully operational.

• Inspect all intake and exhaust vents for obstructions.

• Confirm proper communications from the control

computer to the display(s).

• Assure proper communications between display

faces when applicable.

Topic

Information Shown

Product Name

Galaxy

Display Size

#Rows x #Columns

Shading/Color Depth

4096 (Mono) or 68B (RGB)

Bootloader Version

OS X.XX

Firmware Number

DD1425608

Firmware Revision

Rev X.XX

Hardware Address

HW:XX

Software Address

SW:XX

IP Address:

(default) IP:172.16.192.25

Subnet MSK:

(default) MSK: 255.255.0.0

COM1 Configuration

C1: 115200

COM 2 Configuration C2: RTD
Socket 3001

IP 3001: 115200

Socket 3002

IP 3002: RTD

Line Frequency

CLK: AUTO (60)

Display Description

Galaxy #Rows x #Columns