Daktronics Galaxy AF-3200 34 mm - Manual (Page 8)

Section 2: Mechanical Installation
Read the Mechanical, Power, and Signal Installation sections
before installing the display(s).
Daktronics engineering staff must approve any changes that may affect the
weather-tightness of the display. If any modifications are made, detailed
drawings of the changes must be submitted to Daktronics for evaluation and
approval, or the warranty may be void.
Daktronics is not responsible for installations or the structural integrity
of support structures done by others. The customer is responsible for
ensuring that a qualified structural engineer approves the structure and any
additional hardware.
2.1 Support Structure Requirements
The installer is responsible for ensuring that
the mounting structure and hardware are capable of supporting the display, and
the structure follows all local codes.
Because every installation site is unique, no single procedure is approved by
Daktronics for mounting Galaxy
®
displays. The information contained in this section
is general information only and may or may not be appropriate for this particular
installation. Refer to Figure 3 and Figure 4 for basic display set-ups.
A qualified individual must make all decisions regarding the mounting of this
display.
Support structure design depends on the mounting methods, display size, and weight.
In general, the front of the display needs to be unobstructed to allow for air flow and
internal access. Also keep in mind the location of the mounting clips and the
power/signal termination box or knockouts on the back of the display. Refer to
Figure 5 for the back view of a typical display. Display height and wind loading are
also critical factors to be considered.
Mechanical Installation
2-1