Daktronics Galaxy AF-3200 34 mm - Manual (Page 20)

Section 5: Start-up Procedure
Before starting up the display, go over this checklist to ensure that all parts are ready to
operate correctly. Figure 13 shows the basic display components referred to in each step.
5.1 Start-up Checklist
D
Is power connected to the display?
The power conduit will leave the display from the rear and connect to a power source
either on the display structure or inside a building. Refer to Figure 3 for approximate
location of the power cable or conduit.
D
If the display has two faces, are the two sides connected?
Check that a quick-connect cable or hard-wired communication cable runs between
the back connections of the two display cabinets. Refer to the illustration in Figure
12.
D
Is the control computer connected to the display?
Some type of communication line or wireless device will send signal between the
control computer and the display, depending on the communication method. Refer to
Section 4 for assistance with identifying the communication type.
D
Is the computer software set up to work with the display?
The software manual provides the information necessary to allow the computer to
communicate with the display. Follow the step-by-step directions in the
Configuration section of the manual for correct set-up.
Figure 13: Basic Display Set-up
Start-up Procedure
5-1