Daktronics Galaxy AF-3200 34 mm - Manual (Page 35)

The following table contains some of the items that may need to be
replaced in a display over a period of time. If a circuit board or assembly
is not listed in the Replacement Parts List, look at the label attached to
the part to find the part number. Most circuit boards and components
within this display carry a label that lists the part number of the unit. A
typical label is shown in Figure 22 with the part number in bold.
Figure 22: Typical Label
Cables will not carry a part number label. To assist with correct identification of
cables and connectors, refer to the descriptions in Section 8.3.
Part Description Part Number
Module, 2R, (1:1) 8x16 (30x70), Red 0P-1301-1000
Module, 3A, (1:1) 8x16 (30x70), Amber 0P-1301-1003
Controller II, Louvered Galaxy, 8-connector 0A-1229-0013
Power Supply Assembly, w/Harness, A-1633, Amber
Displays
0A-1327-0009@1
0A-1327-0010@2
Power Supply Assembly, w/Harness, A-1591, Red
Displays
0A-1327-0003@1
0A-1327-0004@2
Transformer; Pri.115V, Sec 10VCT, 3Amp, Primary only T-1119
Filter, RFI Line 10 AMP 115-250 VAC Z-1007
Digital Temperature Sensor 0P-1247-0008
Light Level Detector 0P-1151-0002
Thermostat Enclosure 0A-1213-4024
Fan; 110 CFM@120V @60Hz, 29-24 watt, 4.5" B-1053
Ribbon Cables; 20 Position
Cable Assy; 20 pos Ribbon, 18”, Dual Row W-1387
Ribbon Assy; 20 Pos, 30” 0A-1000-0017
Ribbon Assy; 20 Pos, 36” 0A-1000-0018
Ribbon Assy; 20 Pos, 60” 0A-1000-0021
Ribbon Assy; 20 Pos, 72” 0A-1000-0022
Cable; 22 AWG, 2-pair, shielded (light sensor/temp
sensor to controller)
W-1234
Interconnect Cable; 31-pin male to 31-pin male, 6’, QC W-1503
Quick-connect interface, input, with Ethernet 0P-1229-2004
31-pin, quick-connect input/output board 0P-1229-2008
Parts Replacement 8-2