Daktronics Galaxy AF-3200 34 mm - Manual (Page 10)

Mechanical Installation
2.2 Display Mounting
The installer is responsible for ensuring
the installation adequately meets local codes and standards,
including safe, adequate mounting hardware and procedures.
Note: In order to maintain the structural integrity of the display
cabinet, the 90
° angle between the cabinet and the lifting method must
be maintained.
1. Lift the display into position on the support structure following the
guidelines in Figure 6.
Do not attempt to permanently support the display by the eyebolts.
Figure 6: Correct/incorrect Lifting Procedures
2. Weld or use ½" Grade-5 bolts and hardware to secure the clip angles to the
support structure as shown in the Shop Drawing for a specific display.
3. Refer to Section 3 and the appropriate communication manual for
information on routing power and signal to the display.
4. After installation is complete, carefully inspect the display for any holes
that may allow water to seep into the display and seal any openings with
silicone.
If the eyebolts on the top of the display have been removed, plug the holes
with bolts and the rubber-sealing washer that was removed with the
eyebolt.
2.3 Optional Temperature Sensor Mounting
If a temperature sensor will be used with this display, consult Appendix B for
mounting and signal connections.
2-3