Daktronics Galaxy AF-3200 34 mm - Manual (Page 21)

Start-up Procedure 5-2
5.2 Start-up Sequence
Each time the display is turned on, an initialization sequence will run. The
information in the second column will then be shown on the display.
Note: The Xs refer to numbers that may vary for each display, such as the hardware
address.
Topic Information shown
1. Product Name
• Galaxy®
2. Display Size
• Row x Column
3. Shading
• 64 Mono or RGB 32k
4. Bootloader Version
• OS X.XX
5. Firmware Number
• ED-13305
6. Firmware Revision
• Rev X.XX
7. Hardware Address
• HW:XX
8. Software Address
• SW:XX
9. IP Address:
• (default: IP: 172.16.192.25)
10. Subnet Msk:
• (default) Msk: 255.255.0.0)
11. COM1 Configuration
• C1:V15
(modem: C1:V15 if a modem is present)
12. COM 2 Configuration
• C2: RTD
13. Socket 3001:
• IP 3001: V15
14. Socket 3002:
• IP 3002: RTD
15. Line Frequency
• CLK: AUTO (60)
16. Display Description
• Galaxy # rows x # columns
After this sequence is complete, the display will blank. A single pixel will flash in
the lower right corner of the display to show that the display has power but no
messages are currently running.