Daktronics T-7060 Touchpad - Manual (Page 22)

16 Maintenance & Troubleshooting
6. Attach the black (ground) wire from the replacement cable first.
a. Hang the cable off the right side of the touchpad.
b. Push the grounding screw up from the bottom side of the touchpad.
c. Place the black (ground) wire terminal ring over the screw, followed by the lock
washer and nut.
d. Tighten with a screwdriver and ¼" nut driver (Figure 29).
e. Swing the cable over to the left side of the touchpad so that the black (ground) wire is
now bent in half (Figure 30).
7. Place the box back on top of the touchpad. Bring the screw through the red (positive)
wire terminal ring, then the metal tabs, and secure to the box (Figure 31).
Figure 29: Attaching Black (Ground) Wire
Figure 30: Proper Cable Position
Figure 31: Attaching Red (Positive) Wire