Daktronics T-7060 Touchpad - Manual (Page 18)

12 Maintenance & Troubleshooting
4. Apply supplied double-sided tape to back surface of touchpad along the line that was
just made and cut to length. Ensure the tape is lined up between the pencil line and the
outside edge of the touchpad (Figure 15).
5. Apply supplied double-sided tape to front surface of touchpad on the raised portion of
the stainless steel edge protector and cut to length (Figure 16).
6. Fold tape over the raised portion of stainless steel edge protector (Figure 17).
7. Apply firm finger pressure to the tape on both front and back surfaces across entire
length to ensure proper adhesion (Figure 18).
Figure 15: Applying & Cutting New Tape (Rear)
Figure 16: Applying & Cutting New Tape (Front)
Figure 17: Folding Tape Over Edge Protector
Figure 18: Securing Tape
Pencil Line along
This Edge of Tape