Daktronics T-7060 Touchpad - Manual (Page 20)

14 Maintenance & Troubleshooting
12. After tape liner has been completely removed, apply firm finger pressure to both the
front and back surfaces of the vinyl edge cover to ensure proper adhesion (Figure 23).
13. Repeat steps 1-12 for all vinyl edge covers that need replacing.
4.6 Cable Replacement
If the control cable develops cuts or it has been determined that it has gone bad, it must be
replaced. Follow the steps below.
1. When viewing the touchpad from the rear, locate the black box on the right-hand side
where the input cable is connected. On the underside of this box are 5 screws (Figure 24).
2. Use a screwdriver to remove the 4 corner screws only (Figure 25).
Figure 23: Securing Vinyl Edge Cover
Figure 24: Top & Bottom Rear View of Touchpad
Figure 25: Removing Four Corner Screws