CREATOR CR-PGMIII - Manual (Page 44)

CREATOR CHINA 2011-03 WWW.CREATOR1997.COM
37 PGMⅢ Programmable Ethernet Control System
7.7.6.1 How to insert IR Control code
You can choose the required IR Control code
from the IR Control Codes database to insert into
the program rather than typing in.
A：Firstly, move the cursor to the place to
insert the IR Control code
B：Choose the required IR Control Code from
the data base and double click. And it’s done.
7.7.7 Compile the project
After writing the program and before we upload
the program into the controller, we need to
compile the program.
Click the “Compile” button as shown below:
When compiling, the detailed information will be
shown in the “Output” window:
If some error happens, the software will jump to
the “Error Window”. Double click the error
information will bring you to the corresponding
codes which caused the error;
Then a CR-PGMIII has been finished.
7.8 Upload the program to the
CR-PGMIII
After successfully complied the program, click the
below shown icon to launch the DManger softare:
1,Click the button as shown below:
2,Set up the controller’s IP:
Controller IP: by default it is 192.168.1.20
Port：fixed as 7755
Click Apply to finish.
Compile
Connect the CR-PGMIII’s IP
Upload the program