CREATOR CR-PGMIII - Manual (Page 43)

CREATOR CHINA 2011-03 WWW.CREATOR1997.COM
36 PGMⅢ Programmable Ethernet Control System
Right click at the blank area, and choose IPM at
the pop up menu, then the following dialog will
show up: choose the cir file learnt just now to
open: as shown below:
After successful import, we can see our learnt IR
control codes in the IR Control Codes Database,
as shown in the following image:
7.7.6 Editing the program
After finishing all the above configuration steps,
we need start the programming stage
We want the controller to send out IR control code
for
PLAY when we press down tp_1’s
JOBMONBER 1 button, and send out IR control
code for PAUSE when we press down tp_1’s
JOBMONBER 2 button.
Hereby we need to use the function
SEND_IRCODE （ ） to send out the IR control
codes.
The program is as following:
BUTTON_EVENT(tp_1,1) // tp_1 touch
panel’s JointNumber1
{
PUSH()
{
//send out IR control code for PLAY from
DVD_M
SEND_IRCODE(DVD_M,1,
IRCODE<“UserIRDb:DENON:DVD:RC-1102
:T20110225093436:Paly”);
}
RELEASE()
{
}
}
BUTTON_EVENT(tp_1,2)
//tp_1 touch
panel’s Jointnumber 2
{
PUSH()
{
// send out IR control code for PAUSE
from DVD_M’s IR channel 2
SEND_IRCODE(DVD_M,2,
IRCODE<“UserIRDb:DENON:DVD:RC-1102:
T20110225093436:Pause”>);
}
RELEASE()
{
}
}