Contemporary Control Systems EISC Configurable Switches User Manual - Manual (Page 19)

TD021000-0MB
19
7.2.1
Initial Configuration
With a null-modem cable connecting the EISC to a suitable computer, launch the EISC
Configurator, select a COM port and then click the “Connect” button. If the EISC
Configurator cannot connect to the EISC, the error message of Figure 12 may appear.
If this should happen, check that a proper null-modem cable is used for the connection
and that suitable power is applied to the EISC. If the error in Figure 13 appears, a new
COM port must be chosen.
Figure 12 — Error Connecting to EISC Figure 13 — COMPORT Error
Once the Configurator has connected to the EISC, the display of Figure 14 should
appear — with the Setup and Signal Strength menus now available. The File menu
will remain dimmed so long as the EISC is in communication with the EISC Configurator.
The portions of Figure 14 shown outlined in red will be unavailable (dimmed) for models
EISC12-100T/FC and EISC12-100T/FT.