Comtech EF Data SLM-5650A Vipersat Parameter Editor - Manual (Page 37)

Chapter 2 - Using Parameter Editor 2-21
Vipersat
Figure 2-13 TOS Switch Rules dialog
Click on the Add button to add a new ToS rule, using the dialog shown in
figure 2-14.
• Name – Enter a user-defined text label for circuit identification.
• Identifier – Enter an integer value in the range of 1 to 63. Entering a value
of 0 will result in no switch.
• Switch Type – Enter an integer value in the range of 64 to 254 at the
prompt to inform the VMS what switching policy to use. Entering a value
of 0 will result in no switch.
• Switch Rate – Enter the desired data rate for this service type. Valid
entries are from 0 to 155000000 bps. This setting will override the VMS
set policy value.
• Timeout – This timer monitors the defined packet flow. Once data stops
for the duration of the timer setting, the link state will be restored to the
Home State condition for this Remote. Valid entries are from 1 to 60
seconds.
After field entry, clicking the Add button will update the ToS Switch Rules
table with the new configuration. Note that the Add Type of Service Rule dialog
remains open after adding a rule so that additional rules can be added easily.
Click the Close button to return to the ToS dialog.