Comtech EF Data RAP-100 - Manual (Page 27)

ODU Operation RAP-100 Remote Access Panel
3–10 Rev. 1
3.2.33 (ODU,ENABLE,1:1,CSAT#1,CONFIG,MISCELLANEOUS) XREF(Ext Ref)
(ODU,ENABLE,1:1,CSAT#2,CONFIG,MISCELLANEOUS) XREF(Ext Ref)
(ODU,ENABLE,STAND-ALONE,CONFIG,MISCELLANEOUS) XREF(Ext Ref)
SELECT EXT REFERENCE:
YES NO (PRESS ENTER)
The user is prompted to select either YES or NO, using the LEFT/RIGHT arrow keys,
then to press ENTER. NOTE: The CSAT will automatically lock to an external 5 or 10
MHz reference independent of the state of this selection. This selection determines
whether or not the Summary Fault Relay is activated if the CSAT looses lock with the
external reference.
3.2.34 (ODU,ENABLE,1:1,CSAT#1,CONFIG,MISCELLANEOUS) REF-ADJUST
(ODU,ENABLE,1:1,CSAT#2,CONFIG,MISCELLANEOUS) REF-ADJUST
(ODU,ENABLE,STAND-ALONE,CONFIG,MISCELLANEOUS) REF-ADJUST
EDIT INT REF ADJUSTMENT: 087
(PRESS ENTER)
The user is prompted to edit the Internal 10MHz Reference setting using the UP/Down
arrow keys, then to press ENTER. The value will scroll between 000 and 255. NOTE:
The Internal Refernece is adjusted in the factory to be very accurate with the default
setting of 087. This parameter is made available to compensate for the long-term
frequency drift of the oscillator.
3.2.35 (ODU,ENABLE,1:1,CSAT#1,CONFIG,MISCELLANEOUS) RTC
(ODU,ENABLE,1:1,CSAT#2,CONFIG,MISCELLANEOUS) RTC
(ODU,ENABLE,STAND-ALONE,CONFIG,MISCELLANEOUS) RTC
SYNC ODU RTC TO LCL RTC
YES NO (PRESS ENTER)
The user is prompted to select either YES or NO, using the LEFT/RIGHT arrow keys,
then to press ENTER. Selecting YES will cause the CSAT RTC to be synchronized with
the Modems RTC.
3.2.36 (ODU,ENABLE,1:1,CSAT#1) INFO (Information)
(ODU,ENABLE,1:1,CSAT#2) INFO (Information)
(ODU,ENABLE,STAND-ALONE) INFO (Information)
INFO: MODEL TRANSMITTER
RECEIVER MISC LNA(ENTER)
The operator uses this menu item to select enter 1 of 5 ‘Information Windows’. Use the
LEFT/RIGHT arrow keys, then press ENTER.