Dyna-Glo LP Gas Grill DGP350NP - Manual (Page 31)

LP Gas Grill
CARE AND MAINTENANCE
28 29
Burner Assembly
Cleaning the Burner Assembly – Make sure the grill is cool
1. Turn gas off at the control knobs and propane tank.
2. Disconnect LP-Gas cylinder from hose and regulator.
3. Remove warming rack, cooking grates and heat tents.
4. Detach burner by removing the screws at the back of the burners to detach them
from the brackets.
5. Detach ignition wire from electrode by hand only. DO NOT use pliers or any
other tool as it may damage the electrode or wire.
6. Lift burner slowly.
7. Ensure all burner ports are clear of clogs. Use of a pin or paper clip works well.
8. Ensure burner is free of any damage. If damage is found, replace with new burner.
9. Ensure the end of the burner and primary air screen are clear from insect nests, dirt or debris.
Re-installing the Burner
Ensure that gas valve orifices are correctly positioned inside burner inlet (venturi).
The use of a flashlight may be necessary to ensure the correct position.
It is recommended to view the correct position through the firebox vent holes as illustrated below.
WARNING:
If the instructions above are not followed, a fire or
explosion may result, possibly causing serious bodily injury or death.