Comtech EF Data DMD1050 - Manual (Page 71)

DMD1050 Satellite Modem Board Rear Panel Interface
MN-DMD1050 4–9
Revision 9
4.4.7 ETHERNET M&C (J10)
The Ethernet M&C Port is a 10 Base-T Interface. J10 can be used for the Monitor & Control
(M&C) Functions of the unit. The physical interface is a standard female RJ-45 Connector.
4.5 Ethernet Data Interface (J11)
The DMD1050 Ethernet Data Interface provides two RJ-45, Auto-Crossover and Auto-Sensing,
10/100 Ethernet Data Ports. Refer to Figures 4-3 for configurations.
4.6 BUC & LNB Power Input (J3)
The BUC and LNB input connector allows the user to externally inject DC voltage for the BUC
and LNB voltage. Manufacturer part number for this connector is referenced in Appendix E.
Refer to Table 4-4 for pin out descriptions.
Table 4-4 BUC & LNB DC input connector
Pin No. Signal Name Signal
1 LNB DC Input
2 Ground GND
3 Ground GND
4 BUC DC Input