Comtech EF Data DMD1050 - Manual (Page 21)

MN-DMD1050 2–1
Revision 9
Chapter 2. Installation
This section provides instructions on unpacking and installation, as well as storage of the unit.
2.1 Installation Requirements
Installation of the DMD1050 Modem Board requires adequate planning by the user to ensure no
damage will occur to the unit. Package design considerations for the modem board include
mounting, temperature limits, adequate ventilation, limited vibration, no exposure to
condensation/ moisture and a stable power source.
Mating connectors are supplied with each unit. A full description of the modems pin outs can be
found in Section 4. Appendix E gives details of the various connectors and mating connectors
supplied.
WARNINGS
1. The DMD1050 contains a Lithium Battery. DANGER OF
EXPLOSION exists if the battery is incorrectly replaced. Replace only
with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries in accordance with local and national
regulations
2. Make sure to eliminate the potential for Static Discharge that can
damage the Modem Board.
3. There are no user-serviceable parts or configuration settings located
inside the DMD105.
CAUTION
Before connecting power to the unit, disconnect the transmit output from the
operating ground station equipment. Communication traffic can be disrupted
by connecting power to a unit when the configuration settings are not known
and may be incorrect.
Make sure to obey proper ESD practices to avoid damaging the unit.