beautypg.com

Comtech EF Data DMD1050 User Manual

Page 151

background image

DMD1050 Satellite Modem Board

TCP/IP Ethernet Setup

MN-DMD1050

C–5

Revision 9

3. Make sure that the box next to the Internet Protocol (TCP/IP) is checked. Highlight

Interconnect Protocol (TCP/IP) and click on the Properties button.

Local Area Connection Properties Box


4. Select “Use the following IP Address”. Enter in the IP Address that is offset by 5 or so

numbers from the equipment address (the computer and the equipment that it is connecting to
can not have identical addresses) and Subnet Mask ( this is identical to the subnet mask
programmed into the equipment) into the corresponding fields. Click the OK button to
complete the PC Configuration. Note: some computers may require that the computer be
restarted for the changes to take effect.

Internet Protocol (TCP/IP) Properties Box


5. To reconnect the computer to a network, select the “Obtain an IP address automatically”

selection in the screen shown above.