Compuprint 6314 - Manual (Page 12)

Compuprint 6314/6414 - User Manual
1.8 Installation
The following sections will guide you through the installation of the printer.
- Place the printer in a suitable location on a flat level surface that allows easy access to all sides
of the printer. The printer should never be operated while resting on its side or upside down.
- Check that the printer power switch is in the OFF (O) position.
2
1
Fig. 2 – Power inlet and ON/OFF switch
Legend:
1) AC Power Receptacle
2) ON/OFF Power Switch
- Attach Interface (Fig. 3):
A. Parallel Interface
Attach a suitable parallel printer cable from the computer to the Centronics
®
interface connector
at the back of the printer. Snap the bail locks to the Centronics connector to secure the interface
cable to the printer.
B. Serial Interface
Attach a suitable serial printer cable from the computer to the DB-9 RS-232 Serial interface
connector at the back of the printer. For additional information on serial cable wiring, refer to
“Serial Port Wiring” section on page 76.
C. USB Interface
Attach a suitable USB cable from the computer to the USB interface connector at the back of the
printer.
12