Care Fitness 50733 Computer - Manual (Page 13)

Adjustment
1. Ask the authorized service representative or professional technician to check if the voltage is suitable,
and if the grounded wire is reliable. Pull the running belt by your hand and check if it turns freely, without
screech.
2. Insert one end of the power plug into the socket at the front of the treadmill; plug the other end in to the
electrical supply outlet. Put the emergency stop key on to the corresponding place on the computer.
3. Turn on the switch from “0” to “1”, the computer displays zero, the running belt do not move.
4. Press the “START” key, the treadmill runs slowly, check if the computer and running belt work normally.
5. Press the “SPEED” key, and observe the status of the running belt and display on the computer. Please
turn off the machine if the belt runs defectively, adjust it following the rules in “MAINTENANCE AND
MALFUNCTION TREATMENT”.
6. Check all the functions keys on the computer.
7. Pull out emergency stop key, the treadmill should stop immediately; it’ll work when you put it on again.
8. Press the “STOP” key, the treadmill will stop, and then turn off the switch if you want to finish your
exercise.
Folding, Moving and Unfolding Instruction
1) Folding: The treadmill is foldaway. Lift the end of the main frame and fold upwards until the connecting bar
rebound to the cover of cylinder tube. (See figure a)
2) Moving: Press the handrails to make the front base foot away from the ground then push the treadmill after
folding.
4 ） ） ） ） When you want to put the treadmill to the work position, please lift the end of main fame (end cap) a little
to make the foldaway support tube higher than the cylinder cover (see figure a-1), tip the foldaway
support tube with your foot slightly (see figure a-2), press the end of main fame (end cap) forcibly, remove
your foot and keep on pressing the end of main fame for a while. The cylinder will shrink under the weight
of itself (see figure b) and the main fame goes flat.